It s very important to make sure that you grab the z channel that s below and make sure that you re in the outside leg of the z channel.
Steel roof flashing installation.
Space the screws about 12 in 30 cm apart.
It should match the eave drip that extends along the drip edge of the roof.
I m going to install one between each panel directly in the center.
Hammer one nail to the.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof.
Align the step flashing with the leading edge of the starter course and nail it in place using one nail in the upper corner.
Figure 10 gable flashing is used to trim the edge of the roofing panel at the gable end of the roof.
You can use 1 inch nails for the installation of eave flashing.
Use your neoprene washer head screws to secure the metal to the sheathing.
Bend it back so that it overlaps the corner flashing.
Next you are ready to install the metal roof.
Nail it in place with two nails one.
Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are.
Ensure it sits flat and extends at least 8 inches above the shingles.
If the panel is allowed to hang over the gable end eave drip can be used instead.
Then set the piece down.
How to install step flashing with a wall corner step three.
With the end wall flashing in place i use stitch screws to attach it to the z trim and to the gable trim.
I ve already prepared this trim and you can see beneath it that we re going to install it using z trim as we have throughout the rest of the project.
You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened.
Install the roofing screws vertically along each rib in the panel.
Dealing with dips and making clean overlaps metal drip edge flashing is installed on the perimeter of a roof to direct water away from the fascia into the gutters and to keep wind blown rain image.
Place the first screw.
Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof.
This is not a complete install only basic install on a bungalow i.
I ll make sure to use tape seal in between the flashing and the top of the z and we ll use pop rivets for a concealed fastener installation.
In this video i m installing some metal roofing over an existing ash fault shingled roof.
